Battery Problem Fault

Generac, Guardian, Honeywell, Siemens, Centurion, Watchdog, Bryant, Olympian & Carrier Liquid Cooled Home Standby & Commercial generator troubleshooting and repair questions
Post Reply
JasonT17
New Member
New Member
Posts: 1
Joined: Wed Jul 03, 2019 8:48 pm

Wed Jul 03, 2019 8:52 pm

Installed 38kw
Tested 120v to battery for charging
Battery not being charged
Replaced Controller
Replaced battery 3 times
If put a trickle (stand only) battery charges and everything good
Just stumped why battery not getting charged.
Tech support walked me through steps and said controller but that is not it

Any suggestions
Chris
Site Admin
Site Admin
Posts: 468
Joined: Sat Aug 04, 2018 8:46 pm
Location: Clawson, MI
Contact:

Wed Jul 03, 2019 9:05 pm

Does the controller say 'Charger Status: Not Charging' in the dealer menu?
Generac tech for over 12 years. I'm here to help!
"The only source of knowledge is experience" -Albert Einstein
Looking for Generac parts? Gentek Power offers the full line of Generac replacement parts! Shop Gentek Power Generac Parts
A list of my favorite Generator & Electrical Tools! https://www.amazon.com/shop/gentek_power
78buckshot
Verified Dealer
Verified Dealer
Posts: 91
Joined: Mon Nov 12, 2018 9:45 am
Location: Stockbridge/Chelsea, Michigan

Thu Jul 04, 2019 6:29 am

We installed a 25kw a few years ago that would not charge the battery, had 120 vac into the unit on the T1 circuit but it wasn't getting to the control, found a bad pin or socket in the harness connector. Repaired the connector and it's been trouble free since.
Post Reply