Generac Alarm

Generac, Guardian, Honeywell, Siemens, Centurion, Watchdog, Bryant, Olympian & Carrier Liquid Cooled Home Standby & Commercial generator troubleshooting and repair questions
Post Reply
molservice
New Member
New Member
Posts: 3
Joined: Fri Jul 31, 2020 12:36 pm

I have an alarm going off, it shows - wr no HTS 1 battery. tested batteries in transfer switch and are good. Now alarm has stopped.
Not sure where to look. And is there a way to clear from display? One more question how can I reset oil %? I just did a maintenance on it.

Thanks for any guidance
Chris
Site Admin
Site Admin
Posts: 2209
Joined: Sat Aug 04, 2018 8:46 pm
Location: Clawson, MI
Contact:

Do you have access to GenLink and a security dongle?
Generac tech for over 12 years. I'm here to help!
"The only source of knowledge is experience" -Albert Einstein
Looking for Generac parts? Gentek Power offers the full line of Generac replacement parts! Shop Gentek Power Generac Parts
A list of my favorite Generator & Electrical Tools! https://www.amazon.com/shop/gentek_power
molservice
New Member
New Member
Posts: 3
Joined: Fri Jul 31, 2020 12:36 pm

I don't is there software I could download to my laptop
Chris
Site Admin
Site Admin
Posts: 2209
Joined: Sat Aug 04, 2018 8:46 pm
Location: Clawson, MI
Contact:

Not without a certification from Generac. The software is locked without a special security dongle from Generac and a tech ID number that will allow the software to update and run.
Generac tech for over 12 years. I'm here to help!
"The only source of knowledge is experience" -Albert Einstein
Looking for Generac parts? Gentek Power offers the full line of Generac replacement parts! Shop Gentek Power Generac Parts
A list of my favorite Generator & Electrical Tools! https://www.amazon.com/shop/gentek_power
molservice
New Member
New Member
Posts: 3
Joined: Fri Jul 31, 2020 12:36 pm

Thank you for responding. I was kind of guessing that but was hopeful.
Thanks again
Post Reply