Crankshaft pulley loose

Generac, Guardian, Honeywell, Siemens, Centurion, Watchdog, Bryant, Olympian & Carrier Liquid Cooled Home Standby & Commercial generator troubleshooting and repair questions
Post Reply
Posts: 43
Joined: Fri Dec 04, 2020 5:46 pm

Ser# 8527469
Called to repair bad starter. Replaced starter.
Engine cranked hard, slow. I noticed the crankshaft pulley had slid off the shaft about an inch putting the belts way out of alignment.
Not sure how long it has been in this condition I'm sure it has been awhile. The Dividing metal panel that hold fan shaft bearing has stress cracks all around the fan bearing. Obviously something is out of alignment bad. Has anyone experienced this problem? Not sure what if any engine damage could be present. No oil leaks
I started taking the fan coupling apart but had to stop . Friday quilting time!! Lol
Any help is greatly appreciated.
20240412_134045.jpg (93.01 KiB) Viewed 1338 times
20240412_134049.jpg (96.41 KiB) Viewed 1338 times
20240412_134054.jpg (106.48 KiB) Viewed 1338 times
Post Reply