Page 1 of 1

Stepper Motor *plastic bracket to linkage to carb

Posted: Sun May 12, 2019 11:05 am
by Zade
Hello All,

I have a Generac 15k KW Air cooled model with the 0g0934 engine. When I was re-installing the carb linkage to the stepper motor; I broke the little plastic piece that the linkage goes to. It is the little pieve that has one hex nut and it goes to the stepper. I am having nothing but grief finding it and the local Generac Dealer was ZERO help.

Anyone can help me find this tiny piece?

Thanks,

Zade

Re: Stepper Motor *plastic bracket to linkage to carb

Posted: Sun May 12, 2019 12:01 pm
by Chris
Are you talking about the piece that has a tiny phillips screw attaching it to the actual stepper motor and has the little ball stud in it, or the piece threaded onto the throttle rod?