Gen was run in a overloaded condition

Generac, Guardian, Honeywell, Siemens, Centurion, Watchdog, Bryant, & Carrier Air Cooled Home Standby generator troubleshooting and repair questions
Post Reply
johnstarnes
New Member
New Member
Posts: 1
Joined: Fri May 13, 2022 4:55 pm

20KWHSB
s/n 8345308 09230
Gen was run with to much load and shut down because of overheating.
I have pulled fuse and disconnected battery.
Gen starts good and runs fine.....for about 5-10 seconds, and shuts down again.
It does this without any load on it.
I'm wondering if there is a reset /fusable link somewhere on the generator.
Thanks,
John
mm08822
New Member
New Member
Posts: 10
Joined: Sat Jan 30, 2021 11:53 pm

Are there any error codes ?
nrp3
Verified Dealer
Verified Dealer
Posts: 178
Joined: Sat Nov 10, 2018 9:56 am
Location: NH

The serial number you gave comes up as a pressure washer in Genservice.
Chris
Site Admin
Site Admin
Posts: 5584
Joined: Sat Aug 04, 2018 8:46 pm
Location: Clawson, MI
Contact:

That's an engine serial number, so somewhere on the machine there is another tag with the unit's serial number.
Generac tech for over 12 years. I'm here to help!
"The only source of knowledge is experience" -Albert Einstein
Looking for Generac parts? Gentek Power offers the full line of Generac replacement parts! Shop Gentek Power Generac Parts
A list of my favorite Generator & Electrical Tools! https://www.amazon.com/shop/gentek_power
Post Reply