Honda EM3500sx
-
Sjm1027
- New Member
- Posts: 1
- Joined: Sat Jan 09, 2021 9:42 am
I am trying to remove the carburetor to clean it and can’t for the life of me figure out how to remove a linkage at the very top before I slide out the carb. I have the very small spring next to the thicker rod off but the rod is my problem.
-
Chris
- Site Admin
- Posts: 3304
- Joined: Sat Aug 04, 2018 8:46 pm
- Location: Clawson, MI
- Contact:
Can you post a picture of what you have going on? Honda generators aren't my specialty, but most carbs have the same styles of linkage.
Generac tech for over 12 years. I'm here to help!
"The only source of knowledge is experience" -Albert Einstein
Looking for Generac parts? Gentek Power offers the full line of Generac replacement parts! Shop Gentek Power Generac Parts
A list of my favorite Generator & Electrical Tools! https://www.amazon.com/shop/gentek_power
"The only source of knowledge is experience" -Albert Einstein
Looking for Generac parts? Gentek Power offers the full line of Generac replacement parts! Shop Gentek Power Generac Parts
A list of my favorite Generator & Electrical Tools! https://www.amazon.com/shop/gentek_power
-
Birken Vogt
- Generator Guru
- Posts: 328
- Joined: Sun Nov 11, 2018 12:02 am
If I recall correctly you slide the carb off the studs with the linkage still connected and then tip it to get it past the zigzag part.